Friday, September 22, 2023

BAR Fleet #143 - Deltie Airshow

Source: Scratch-built Edmonds Aerospace design.  Designed by Robert Edmonds II.

Type: Boost Glider

Motor size: 18mm

Revovery: glide (three vehicles), streamer (booster vehicle)

Booster length: 42.86m (16.9 in.)

Booster diameter: 18.7mm (.736 in.)

Booster weight: 24.3g (.86 oz.)

Glider length (typ.): 27.2cm (10.71 in.)

Glider wingspan (typ.): 23.2cm (9.1 in.)

Glider weight (typ.)*:  7.1g (.25 oz.)

Overall model length: 56.2cm (22.1 in.)

Overall model weight empty*: 45.5g. (1.6 oz.)

*Trim clay weight not included

Color scheme: White, black, blue, red, silver trim.

Completion date: September 21, 2023

Triple The Glider Fun!

My favorite aspect of the model rocketry hobby is building and flying boost/gliders and rocket gliders.

When I happened upon published plans for the Edmonds Deltie Airshow, I knew immediately that such a model was a must-have for the fleet.

Coupled with the fact that there are three gliders in the mix, they are of an unusual delta-wing planform that has a lot of that 'cool' factor.

The model was actually started back in July, 2022 alongside a number of other builds. It just takes me a long time to build and complete a model rocket, what with all of the other hobbies and activities that vie with rocketry work-bench time.

This build is fairly straight-forward albeit with a lot of balsa parts. 

In the original kit, the glider parts were all pre-cut with the inclusion of numerous interlocking assembly tabs.  The kit was intended for rocketeers building their first glider model.

I chose to cut all of the parts out of balsa sheet stock minus the tabs. The fuselage, wings, and vertical stabs are all butt-jointed on this version.

The booster rocket is constructed from Estes components.  One deviation made on the booster fins was the substitution of basswood stock for the glider attachment parts. I found that the original balsa pieces were far too weak and broke easily.

The Edmonds plans called for flying the Airshow with gliders unfinished.

I applied my usual glider finishing method of spraying on a thin application of white primer, light sanding, followed by color and markings using permanent markers.

The booster rocket is brush-painted with gloss hobby acrylics.

This should be a very fun bird to launch on a large field. It will likely require the employment of a substantial recovery crew!


2 comments:

  1. "We're gonna need a bigger boat, err, field."

    And at least 4 trackers for that launch. Can't wait to see them fly!

    ReplyDelete
    Replies
    1. This one will definitely have to wait until Dove Valley opens up next Spring.

      Delete